LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Transmission >> Clutch >> Clutch System >> Clutch Pedal >> Installation

Clutch Pedal: Installation

  1. Install in the reverse order of removal.
    CAUTION: Always use a new clevis pin.

    Tightening torque: 

    T: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

  2. Fill the recommended clutch fluid. Refer to Clutch Fluid .
  3. Bleed air from the clutch system. Refer to PROCEDURE  .
  4. Adjust the clutch pedal. Refer to ADJUSTMENT  .
  5. When the clutch pedal has been replaced, perform the clutch sensor calibration mode. Refer to CLUTCH ENGAGEMENT POSITION SETTING .
    NOTE: If necessary, perform the clutch meet position setting. Refer to CLUTCH ENGAGEMENT POSITION SETTING .
  6. Install the collector cover.
scientia non olet · About LEMON Manuals