LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Occupant Detection System (Diagnostics)) >> Subaru Select Monitor >> Operation >> Clear Memory Mode

Clear Memory Mode

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Clear the DTC stored in the airbag control module after repairing the airbag system and occupant detection system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)

  1. On the «Main Menu» display, select {Each System Check}.
  2. On the «System Selection Menu», select {Airbag System}.
  3. On the «Airbag System» display screen, select the {Clearing Memory}.
  4. When the "Clear Memory?" is shown on the screen, press [OK].
  5. When "Done" is displayed, end the Subaru Select Monitor.
    NOTE: For details concerning the operation procedure, refer to the "PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals