Confirmation Of Current Setting
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Integ. unit mode}.
- On «Integ. unit mode failure diag display, select {Current Data Display & Save}.
- On the «Current Data Display & Save» display screen, select the {Data Display}.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
- Display the following item and record the settings.
Required items for new registration (Except for system not equipped)
| Item | Item to confirm | Remarks | |||
|---|---|---|---|---|---|
| # of reg key | 1 | 2 | 3 | 4 | Registered ID type |
| Off delay time | OFF | Long | Normal | Short | Setting for lighting off time |
| Auto lock time | 60, 50, 40, 30, 20 | OFF | Not applicable for U.S. models (Unit: second) | ||
| Rr defogger op. mode | Normal | Continuous | Normal: OFF after 15-minute operation Continuous: From switch ON to OFF |
||
| Wiper deicer op. mode | Normal | Continuous | Normal: OFF after 15-minute operation Continuous: Repeat ON (for 15 minutes) and OFF (for 2 minutes) from switch ON to OFF. |
||
| Security Alarm Setup | ON | OFF | ON: Security alarm operable OFF: Security alarm not in operation |
||
| Impact Sensor Setup | ON | OFF | ON: Impact sensor operable OFF: Impact sensor not in operation For vehicles without impact sensor, set to OFF. |
||
| Alarm delay setup | ON | OFF | ON: Observation mode starts after a certain period of time from keyless lock signal reception. OFF: Observation mode starts right after keyless lock signal reception. |
||
| Lockout prevention | ON | OFF | Not applicable for U.S. models | ||
| Impact sensor | support | no support | Support: Impact sensor equipped No support: Impact sensor not equipped For vehicles without sensor, set to No support. |
||
| Siren setting | support | no support | Not applicable for U.S. models | ||
| Answer-back buzzer setup | ON | OFF | ON: Answer-back buzzer operable OFF: Answer-back buzzer not in operation |
||
| Hazard answer-back setup | ON | OFF | ON: Hazard answer-back buzzer operable OFF: Hazard answer-back buzzer not in operation |
||
| Automatic locking setup | ON | OFF | Not applicable for U.S. models | ||
| Ans.-back Buzzer | support | no support | Support: Vehicles with answer-back buzzer No support: Vehicles without answer-back buzzer |
||
| Auto locking | support | no support | Not applicable for U.S. models (set to No support) | ||
| Passive Alarm | ON | OFF | |||
| Door open warning (battery run-out prevention) | support | no support | Support: If detecting door open for 10 minutes, door interlocked room light is turned to off. No support: Room light continues to illuminate until the door is shut properly. |
||
| Dome Light Alarm Setting | support | no support | Support: Room light continues to illuminate according to alarm operation. No support: Room light illuminates then goes off regardless of alarm operation. |
||
| Map Light Setting | support | no support | Support: Map light illuminates in accordance with the door interlocked room light. No support: Not illuminate in accordance with the door interlocked room light. |
||
| Belt Warning Switch | ON | OFF | ON: Normal use status OFF: Stops the belt warning buzzer beep and warning light illumination. |
||
| A/C ECM setting | support | no support | Models with auto A/C (set to Support.) | ||
| wiperdeicer | support | no support | Support: Vehicles with wiper deicer No support: Vehicles without wiper deicer |
||
| Rear fog light setting | support | no support | Not applicable for U.S. models (set to No support) | ||
| Factory or Market setting | Factory | Market | Do not change to factory mode. For normal use, set to Market. | ||