Front Seat: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

After installing the driver's seat, use the Subaru Select Monitor to confirm that the seat position sensor LH is operating properly. Refer to SUBARU SELECT MONITOR DISPLAY OF STATUS INFORMATION, OPERATION, Subaru Select Monitor.
If a front seat is power seat with memory function, the memory function must be initialized after installing seat to the vehicle. Refer to ADJUSTMENT , Power Seat System. If it is not initialized, the memory function may not operate properly.

Install in the reverse order of removal.

NOTE: Tighten the slide rail installing bolt gradually in several steps to the specified torque in the order as shown in the figure.

Fig 1: Identifying Slide Rail Installing Bolt

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque:

Refer to "COMPONENT" of "General Description". Refer to COMPONENT , General Description.