LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Automatic Transmission) >> Turbine Speed Sensor 1 >> Removal

Turbine Speed Sensor 1: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the under cover.
  5. Remove the front exhaust pipe.
  6. Clean the transmission exterior.
  7. Disconnect the turbine speed sensor 1 connector.
    Fig 1: Identifying Turbine Speed Sensor 1 Connector
    G05022250Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the turbine speed sensor 1.
scientia non olet · About LEMON Manuals