LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Automatic Transmission) >> Reduction Driven Gear >> Removal

Reduction Driven Gear: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission assembly from vehicle body. Refer to REMOVAL , Automatic Transmission Assembly.
  2. Remove the rear vehicle speed sensor, and separate the extension case from transmission case. Refer to REMOVAL , Extension Case.
  3. Remove the center differential carrier. Refer to REMOVAL , Center Differential Carrier.
  4. Set the range select lever to the "P" range.
  5. Using ST1, ST2 and ST3, pull out the reduction driven gear.

    ST1 499737100 PULLER SET

    ST2 18680AA010 GEAR HOLDER

    ST3 18766AA000 SUPPORT PULLER

    Fig 1: Pulling Out Reduction Driven Gear
    G06342962Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals