LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting System) >> Rear Combination Light Assembly >> Removal

Rear Combination Light Assembly: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from the battery.
  2. Remove the cover.
    Fig 1: Locating Cover
    G05033365Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the two bolts, and then detach the rear combination light by pulling it to the rear side of vehicle.
    Fig 2: Locating Rear Combination Light Bolts
    G05033366Courtesy of SUBARU OF AMERICA, INC.
  4. After turning the sockets of the tail/stop light bulbs and rear turn signal light bulbs, remove the rear combination light.
scientia non olet · About LEMON Manuals