LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Air Bag System) >> Side Airbag Sensor >> Removal

Side Airbag Sensor: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the center pillar lower trim. Refer to CENTER PILLAR LOWER TRIM , REMOVAL, Side Trim.
  4. Remove the seat belt retractor of the front outer seat belt. Refer to OUTER SEAT BELT ASSEMBLY , REMOVAL, Front Seat Belt.
  5. Remove the nut and disconnect the airbag connector to remove side airbag sensor.
    Fig 1: Identifying Side Airbag Sensor
    G00510770Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals