LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Air Bag System) >> Roll Connector >> Removal

Roll Connector: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
  3. Remove the driver's airbag module. Refer to REMOVAL , Driver's Airbag Module.
  4. Remove the steering wheel. Refer to REMOVAL .
  5. Remove the steering column cover.
  6. Remove the screws, and then remove the roll connector.
    Fig 1: Locating Steering Roll Connector With Mounting Bolts And Nuts
    G05033137Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals