Check Rear Gate/Trunk Opener Button Switch Circuit

Step	Check	Yes	No
1 CHECK REAR GATE/TRUNK OPENER BUTTON SWITCH. Prepare the Subaru Select Monitor kit. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor". On << System Selection Menu >> display, select {Integ. unit mode}. Select the {Current Data Display & Save}. Select the {Rear gate/Trunk release switch}.	Does the display switch between OFF ↔ ON when the rear gate/trunk opener button is operated?	The rear gate/trunk opener button is normal.	Go to step 2 .
2 CHECK HARNESS. Disconnect the body integrated unit connector and rear gate/trunk opener button connector. Measure the resistance between body integrated unit connector and rear gate/trunk opener button connector. Connector & terminal Sedan model (i84) No. 10 - (i162) No. 4: OUTBACK model (i84) No. 10 - (D77) No. 5:	Is the resistance less than 10 Ω?	Go to step 3.	Repair or replace the harness.
3 CHECK HARNESS. Measure the resistance between the rear gate/trunk opener button connector and chassis ground. Connector & terminal Sedan model (i162) No. 2 - Chassis ground: OUTBACK model (D77) No. 6 - Chassis ground:	Is the resistance less than 10 Ω?	Go to step 4.	Repair or replace the harness.
4 CHECK REAR GATE/TRUNK OPENER BUTTON SWITCH. Measure the resistance between connector terminals both when the rear gate/trunk opener button is pressed and when not pressed. Connector & terminal Sedan model (i162) No. 4 - (i162) No. 2: OUTBACK model (D77) No. 5 - (D77) No. 6:	Is the resistance less than 10 Ω when the switch is pressed and 1 MΩ or more when not pressed?	Replace the body integrated unit. Refer to , BODY INTEGRATED UNIT .	Replace the rear gate/trunk opener button.