Roll Connector: Removal

Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
Turn the ignition switch to OFF.
Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
Remove the driver's airbag module assembly.
Preparation tool: TORX® T30
1. Loosen the TORX® bolts located on the sides of the steering wheel.
  
  Fig 1: Locating Snap Pins And Locks
  Courtesy of SUBARU OF AMERICA, INC.
2. Disconnect the airbag connector and remove the airbag module assembly. Refer to Airbag Connector .
3. Disconnect the horn harness.
  
  Fig 2: Disconnection Horn Harness
  Courtesy of SUBARU OF AMERICA, INC.
Remove the steering wheel.
CAUTION:
- Always use the steering wheel puller for removal to avoid deforming the steering wheel.
- If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.
1. Disconnect the connector and remove the nut.
2. Put alignment marks and remove the steering wheel.
Fig 3: Locating Steering Wheel Nut
Courtesy of SUBARU OF AMERICA, INC.
Remove the steering column cover.
1. Lower the lever of the steering column.
2. Release the claws and remove the screws, then detach the steering column lower cover.
  
  Fig 4: Locating Steering Column Cover Screws
  Courtesy of SUBARU OF AMERICA, INC.
3. Separate the steering column upper cover and steering upper cover, and remove the steering column upper cover.
Fig 5: Identifying Steering, Column Upper Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the roll connector.
CAUTION: Make sure that the roll connector is not turned from the original position.
1. Disconnect the connector under the roll connector.
2. Release the claws and remove the roll connector.
Fig 6: Identifying Roll Connector
Courtesy of SUBARU OF AMERICA, INC.