LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Clutch System) >> Master Cylinder >> Removal

Master Cylinder: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Remove the collector cover. (turbo model)
  3. Thoroughly drain the clutch fluid from the reservoir tank.
  4. Remove the instrument panel lower cover. Refer to INSTRUMENT PANEL LOWER COVER .
  5. Remove the pedal assembly. Refer to REMOVAL  .
  6. Remove the clip and clevis pin, and then separate the push rod of the master cylinder from clutch pedal.
    Fig 1: Identifying Clip And Clevis Pin With Push Rod
    G07913872Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the clutch stroke sensor connector.
  8. Remove the clutch pipe from the master cylinder.
    Fig 2: Locating Clutch Pipe Nuts
    G06652539Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the master cylinder from the pedal bracket.
Fig 3: Identifying Master Cylinder With Nuts
G07913874Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals