LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Anti-Theft System - Security And Locks) >> Body Integrated Unit >> Removal

Body Integrated Unit: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When replacing the body integrated unit, check the current setting and note it. Refer to SUBARU SELECT MONITOR CONFIRMATION OF CURRENT SETTING, OPERATION, Subaru Select Monitor.
  • When replacing the body integrated unit, all immobilizer keys also must be replaced and registered again. Prepare the new immobilizer key and security ID plate.
  1. Disconnect the ground cable from battery.
  2. Remove the instrument panel lower cover. Refer to INSTRUMENT PANEL LOWER COVER REMOVAL, Instrument Panel Lower Cover.
  3. Disconnect the connector of body integrated unit.
    CAUTION:
    • Be careful to keep water and other foreign materials away from body integrated unit.
    • Do not install or register an immobilizer related module of other registered vehicles in order to diagnose failures or inspect functions.
  4. Remove two mounting nuts for body integrated unit bracket, and remove the bracket.
Fig 1: Locating Body Integrated Unit Bracket Mounting Nuts
G05033667Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals