Input Clutch

WARNING: This page is about a different variant/trim than selected.

Check the clearance of the input clutch. Measure the clearance "L" between snap ring and retaining plate using a thickness gauge. If it is out of specification, replace the entire input clutch assembly.
Check for damage on the drive plate, driven plate and snap ring, and replace the entire input clutch assembly if damaged.
Standard:

0.7 - 1.1 mm (0.028 - 0.043 in)

Fig 1: Measuring Clearance Between Snap Ring And Retaining Plate Of Input Clutch Using Thickness Gauge
Courtesy of SUBARU OF AMERICA, INC.