LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2012 >> Impreza WRX STi Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (WRX-STI) >> Rear Oxygen Sensor >> Removal

Rear Oxygen Sensor: Removal

  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G07704513Courtesy of SUBARU OF AMERICA, INC.
  2. Lift up the vehicle.
  3. Remove the transmission under cover.
  4. Disconnect the connector from the rear oxygen sensor, and remove the clip (A) holding the rear oxygen sensor harness.
    Fig 2: Locating Rear Oxygen Sensor Connector
    G07704514Courtesy of SUBARU OF AMERICA, INC.
  5. Apply spray-type lubricant to the threaded portion of rear oxygen sensor, and leave it for one minute or more.
  6. Remove the rear oxygen sensor.
    CAUTION: When removing the rear oxygen sensor, wait until exhaust pipe cools, otherwise it will damage the exhaust pipe.
    Fig 3: Locating Threaded Portion Of Rear Oxygen Sensor
    G07704515Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals