Front Hub Unit Bearing: Installation
WARNING: This page is about a different variant/trim than selected.
- Place the disc cover between housing (A) and front hub unit, and tighten the four bolts.
Tightening torque: 65 N.m (6.63 kgf-m, 47.9 ft-lb)
- Install the front drive shaft. < Ref. to INSTALLATION , Front Drive Shaft. >
- Tighten the axle nut temporarily.
- Install the disc rotor to hub.
- Install the disc brake caliper on the housing.
Tightening torque:
17-inch type 155 N.m (15.81 kgf-m, 114.3 ft-lb)
16-inch type 80 N.m (8.16 kgf-m, 59 ft-lb)
- While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.CAUTION: Do not apply weight to the front axle before tightening the axle nut. Doing so may damage the hub bearing.
Tightening torque: 220 N.m (22.43 kgf-m, 162.3 ft-lb)
- After tightening the axle nut, lock it securely.
- Install the wheel.
Tightening torque: 100 N.m (10.20 kgf-m, 73.8 ft-lb)