Rear Hub Unit Bearing: Disassembly
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Using the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).
CAUTION:
- Be careful not to hammer the hub bolts. This may deform the hub.
- Do not reuse the hub bolt.
PREPARATION TOOL:
ST: HUB STAND (28399AG000)
NOTE:
Since the hub unit bearing can not be disassembled, only hub bolts can be removed.