Transfer Clutch: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Apply vaseline to the seal ring and attach it to the seal ring groove of transfer clutch assembly.
NOTE:
- Use a new seal ring.
- When installing the seal ring, do not expand the seal ring too much.
  
  Fig 1: Locating Seal Ring On Transfer Clutch Assembly (View 2 Of 2)
  Courtesy of SUBARU OF AMERICA, INC.
Install the transfer clutch assembly.

Fig 2: Identifying Transfer Clutch Assembly
Courtesy of SUBARU OF AMERICA, INC.
Select the thrust needle bearing. Refer to , ADJUSTMENT , Rear Drive Shaft.
Install the selected thrust needle bearing and needle bearing to transfer clutch assembly.
NOTE: Install the thrust needle bearing in the correct direction.

Fig 3: Identifying Thrust Needle Bearing
Courtesy of SUBARU OF AMERICA, INC.
Install the rear drive shaft. Refer to , INSTALLATION , Rear Drive Shaft.
Install the extension case. Refer to , INSTALLATION , Extension Case.
Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.