Preparation for Overhaul: Procedure

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Clean the transmission exterior.
Remove the torque converter assembly. Refer to , TORQUE CONVERTER ASSEMBLY .
Attach the ST on the transmission.
ST 18632AA000 STAND ASSY

Fig 1: Identifying Stand ASSY On Transmission
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission cover on the transmission upper side.
NOTE: Install using the following tightening torque.

Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 2: Identifying Transmission Cover On Transmission Upper Side
Courtesy of SUBARU OF AMERICA, INC.
Place the transmission assembly on end.