Oil Level Switch: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Route the oil level switch harness as shown in the figure.

Fig 1: Identifying Oil Level Switch Harness
Courtesy of SUBARU OF AMERICA, INC.
Attach the oil level switch to the oil pan upper.
NOTE:
- Use new O-rings.
- Apply engine oil to O-ring.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 2: Locating Oil Level Switch Mounting Screws
Courtesy of SUBARU OF AMERICA, INC.
Attach the clips which hold the front camshaft cap (LH) and cylinder head (LH).

Fig 3: Locating Front Camshaft Cap Holding Clips
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Locating Cylinder Head Holding Clips
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector of the oil level switch to the engine harness.

Fig 5: Locating Oil Level Switch Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover. Refer to FRONT UNDER COVER .
Lower the vehicle.
Refill the engine oil. Refer to , REPLACEMENT , Engine Oil.
Check the engine oil level. Refer to , INSPECTION , Engine Oil.