LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (LAN System Diagnostics) >> CAN Communication Circuit Check >> Inspection >> Battery Short Inspection >> Wiring Diagram

Battery Short Inspection: Wiring Diagram

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Battery Short Wiring Diagram
G07914623Courtesy of SUBARU OF AMERICA, INC.
NOTE: Main wiring harness or related lines may be shorted to battery circuit, or shorted to battery circuit in one of the control modules.
Step Check Yes No
1 CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS. 
  1. Turn the ignition switch to ON.
  2. Using the tester, measure the voltage between terminals.

    Connector & terminal 

    (B40) No. 6 - Chassis ground: 

    (B40) No. 14 - Chassis ground: 

 Is the resistance 5 V or less? Currently returned to normal. Go to step 2. 
2 CHECK CONTROL MODULE. 
With the tester connected, disconnect control module.
NOTE: Disconnect the body integrated unit at the end.

Connector & terminal 
(B40) No. 6 - Chassis ground: 
(B40) No. 14 - Chassis ground: 		 Did the voltage change to 5 V or less? Replace the control module whose voltage has changed. When the value changed at disconnecting the body integrated unit, go to next. Go to step 3.  Go to step 3. 
3 CHECK BETWEEN MAIN WIRING HARNESSES. 
Using the tester, measure the resistance between terminals.
Connector & terminal 
(i84) No. 27 - Chassis ground: 
(i84) No. 35 - Chassis ground: 		 Is the voltage 1 V or less? Replace the body integrated unit. Refer to BODY INTEGRATED UNIT . Repair or replace the short circuit of the harness.
scientia non olet · About LEMON Manuals