Rear Seat: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install each part in the reverse order of removal.

CAUTION: If the hook is removed from vehicle body, replace the hook with the new part to avoid the deterioration of seat securing.

Fig 1: Identifying Hook

Courtesy of SUBARU OF AMERICA, INC.

NOTE:

After installing the backrest, make sure that each seat belt operates normally.
Check that the remote lever and reclining lever operate normally.
Make sure that they are properly secured on each hook on the vehicle side.

Tightening torque:

Refer to " COMPONENT " of "General Description".

Sedan model: Refer to , REAR SEAT (SEDAN MODEL) , COMPONENT, General Description. OUTBACK model Refer to , REAR SEAT (OUTBACK MODEL) , COMPONENT, General Description.