Rear Sub Frame: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be sure to use a new self-locking nut.
- Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
- Check the removed parts for wear, damage and crack, and repair or replace them if faulty.
- Install each part in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque. Refer to , COMPONENT , General Description.
- Bleed air from brake system.
- Inspect the wheel alignment and adjust if necessary.