LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Outback R Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Fuel Injection Fuel Systems (H6DO)) >> Knock Sensor >> Removal

Knock Sensor: Removal

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Remove the intake manifold. Refer to , REMOVAL , Intake Manifold.
  4. Disconnect the knock sensor connector.
  5. Remove the knock sensor from cylinder block.
    Fig 2: Identifying Knock Sensor Of Cylinder Block
    G06651250Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals