Transmission Harness: Removal

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Remove the transmission from the vehicle. Refer to , REMOVAL , Automatic Transmission Assembly.
Prepare for overhaul. Refer to , PREPARATION FOR OVERHAUL .
Remove the transmission harness ground terminal and remove the harness connectors from front wheel speed sensor and secondary speed sensor.

Fig 1: Locating Transmission Harness Connectors
Courtesy of SUBARU OF AMERICA, INC.
Remove the harness connectors from inhibitor switch, primary speed sensor and secondary pressure sensor.

Fig 2: Locating Harness Connectors On Inhibitor Switch, Primary Speed Sensor And Secondary Pressure Sensor
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission harness stay.

Fig 3: Locating Transmission Harness Stay
Courtesy of SUBARU OF AMERICA, INC.
Remove transmission harness connector and inhibitor harness connector from harness stay.
Remove the control valve body. Refer to , REMOVAL , Control Valve Body.
Remove the mounting bolt to pull out the bushing of transmission harness from transmission case round hole.

Fig 4: Locating Transmission Harness Bushing Mounting Bolt
Courtesy of SUBARU OF AMERICA, INC.
Remove the harness clip from transmission assembly.