Transmission Harness: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal.
NOTE:
- Use new O-rings.
- Do not impact or bend the transmission harness because it has the oil temperature sensor inside.
- Install the transmission ground terminal at an angle of 45° approximately.
Tightening torque:
T1: 5 N.m (0.5 kgf-m, 3.7 ft-lb)
T2: 16 N.m (1.6 kgf-m, 11.8 ft-lb)