LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Outback Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Manual Transmission And Differential) >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the manual transmission assembly from the vehicle. Refer to Manual Transmission Assembly  .
  2. Remove the transfer case together with the extension case assembly. Refer to Transfer Case and Extension Case Assembly  .
  3. Remove the transmission case. Refer to Transmission Case  .
  4. Remove the drive pinion shaft assembly. Refer to Drive Pinion Shaft Assembly  .
  5. Remove the main shaft assembly for single-range. Refer to Main Shaft Assembly for Single-Range  .
  6. Remove the front differential assembly.
    NOTE:
    • Do not confuse the right and left roller bearing outer races.
    • Be careful not to damage the oil seal of retainer.
      Fig 1: Removing Front Differential Assembly
      G05003046Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the differential side retainers using ST.

    ST 18658AA020 WRENCH COMPL RETAINER

    Fig 2: Removing Differential Side Retainers Using ST
    G06652376Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the bearing outer race from the transmission case.

    ST 398527700 PULLER ASSY

scientia non olet · About LEMON Manuals