LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2011 >> Outback Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Vehicle Dynamics Control) >> Rear ABS Wheel Speed Sensor >> Removal

Rear ABS Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle, and then remove the rear wheels.
  3. Remove the rear ABS wheel speed sensor.
CAUTION:
  • Be careful not to damage the sensor.
  • Do not apply excessive force to the sensor harness.
  • Leave the sensor harness clamp on the vehicle side.
    1. Remove the clips and turn over the mud guard.
    2. Disconnect the connector from the rear ABS wheel speed sensor, and remove the grommet.
      Fig 1: Locating Connector From Rear ABS Wheel Speed Sensor
      G00525736Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the harness clamp and bolts, and remove the rear ABS wheel speed sensor from the rear axle housing.
      Fig 2: Locating Rear ABS Wheel Speed Sensor From Rear Axle Housing And Bolts
      G00525737Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals