LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Outback R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Drive Pinion Shaft Assembly >> Installation

Drive Pinion Shaft Assembly: Installation

  1. Assemble the drive pinion assembly to oil pump cover.
    NOTE: Be careful not to bend the shim.

    Tightening torque: 

    70 N.m (7.1 kgf-m, 51.6 ft-lb) 

    Fig 1: Identifying Drive Pinion Shaft Mounting Bolts
    G05022351Courtesy of SUBARU OF AMERICA, INC.
  2. Adjust the tooth contact between drive pinion shaft assembly and the front differential side gear. Ref. to ADJUSTMENT , Drive Pinion Shaft Assembly.
  3. Join the converter case with the transmission case. Ref. to INSTALLATION , Converter Case.
  4. Install the transmission harness connector to the stay.
  5. Install the ATF cooler pipe. Ref. to INSTALLATION , ATF Cooler Pipe and Hose.
  6. Install the torque converter assembly. Ref. to INSTALLATION , Torque Converter Assembly.
  7. Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
scientia non olet · About LEMON Manuals