LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Outback R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Continuously Variable Transmission) >> Reduction Driven Gear >> Installation

Reduction Driven Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the straight pin to reduction driven gear assembly.
    Fig 1: Locating Straight Pin
    G06654607Courtesy of SUBARU OF AMERICA, INC.
  2. Fit the straight pin portion to the recess portion of transmission case and install the reduction driven gear and install the snap ring.
    Fig 2: Identifying Reduction Driven Gear Assembly
    G06654606Courtesy of SUBARU OF AMERICA, INC.
  3. Select the snap ring. Ref. to ADJUSTMENT , Reduction Driven Gear.
  4. Install the selected snap ring.
  5. Install the forward clutch assembly. Ref. to INSTALLATION , Forward Clutch Assembly.
  6. Install the intermediate case. Ref. to INSTALLATION , Intermediate Case.
  7. Install the transfer reduction driven gear assembly. Ref. to INSTALLATION , Transfer Reduction Driven Gear.
  8. Install the transfer clutch assembly. Ref. to INSTALLATION , Transfer Clutch.
  9. Install the rear drive shaft. Ref. to INSTALLATION , Rear Drive Shaft.
  10. Install the extension case. Ref. to INSTALLATION , Extension Case.
  11. Install the transmission to vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
scientia non olet · About LEMON Manuals