Section 90 (Front Suspension): Cradle: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install each part in the reverse order of removal.
CAUTION:
- Use a new bolt and self-locking nut. For parts which are not reusable, refer to "COMPONENT". Refer to , COMPONENT , General Description.
- Perform installation of the universal joint when the tilt position of the steering column is at the lowest position.
- Tighten the bolts of the universal joint in the order of gearbox side and column shaft side.
- Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.
NOTE: Replace the gasket of the throttle body with a new gasket.

Tightening torque:

Front suspension-related parts: Refer to , COMPONENT , General Description.

Steering gearbox-related parts: Refer to STEERING GEARBOX .
Inspect the wheel alignment and adjust if necessary.