LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Outback Premium, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Fuel Injection Fuel Systems (H6DO)) >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knock sensor to the cylinder block.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    NOTE: For the knock sensor installation angle, refer to the figure below.
    Fig 1: Identifying Knock Sensor Installation Angle
    G07912320Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the knock sensor connector.
  3. Install the intake manifold. Refer to , INSTALLATION , Intake Manifold.
  4. Connect the battery ground terminal.
  5. Install the collector cover.
scientia non olet · About LEMON Manuals