Check ECO Gauge

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Step	Check	Yes	No
1 CHECK DIAGNOSTIC TROUBLE CODE (DTC). Prepare the Subaru Select Monitor kit. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor". On << System Selection Menu >> display, select {Integ. unit mode}. Select the {Diagnostic Code(s) Display}.	Is a DTC of high-speed CAN detected?	Perform the diagnosis according to DTC. Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .	Go to step 2.
2 CHECK ECO GAUGE. Perform the self-diagnosis of combination meter. Refer to , SELF-DIAGNOSIS DISPLAY MODE , OPERATION, Combination Meter System.	Does ECO gauge operate properly?	Check the connection status of the harness and connector that may have a temporary poor contact.	Replace the meter case assembly. Refer to , COMBINATION METER .