Front Hub Unit Bearing: Installation
- Place the disc brake cover between housing and front hub unit, and tighten the four bolts.
Tightening torque: 65 N.m (6.6 kgf-m, 47.9 ft-lb)
- Install the front drive shaft. Ref. to INSTALLATION , Front Drive Shaft.
- Tighten the axle nut temporarily.
- Install the disc rotor to hub.
- Install the disc brake caliper on the housing.
Tightening torque: 120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Install the front ABS wheel speed sensor.
Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
- While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque: 220 N.m (22.4 kgf-m, 162.3 ft-lb)
CAUTION: Do not load the front axle before tightening the axle nut. Doing so may damage the hub bearing. - After tightening the axle nut, lock it securely.
- Install the wheel.
Tightening torque: 120 N.m (12.2 kgf-m, 88.5 ft-lb)