Injector Control (Injection Quantity Control)
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. Refer to
OPERATION , Clear Memory Mode.
- On «System Operation Check Mode» display, select {Injector Control}.
- On «Injector Control» display, select {Injection Quantity Control}.
- On «Start the Engine» display, start the engine and click the [OK] button.
- In the «Injection Quantity Control» display, click the [↑] button or the [↓] button to change the setting values, then click the [OK] button.
Setting is possible in a range between 0 - 20%, in increments of 1 %.
- Click the [Cancel] button to stop the injection quantity control.
- Click the [F12] Exit] button to end the injection quantity control. The screen will return to the «Injector Control» screen.NOTE: For detailed operation procedures, refer to "Subaru Select Monitor ".