Differential Case Assembly

Remove the taper roller bearing using the ST and the press.
ST 498077000 REMOVER

Fig 1: Identifying Taper Roller Bearing
Courtesy of SUBARU OF AMERICA, INC.
Secure the case in a vise, remove the hypoid driven gear tightening bolts, and then separate the hypoid driven gear into differential case (RH) and differential case (LH).

Fig 2: Removing Hypoid Driven Gear Tightening Bolts
Courtesy of SUBARU OF AMERICA, INC.
Pull out the straight pin and pinion shaft, then remove the differential bevel gear, washer and differential bevel pinion.

Fig 3: Pulling Out Straight Pin

Courtesy of SUBARU OF AMERICA, INC.