AT Shift Lock Solenoid and "P" Range Switch: Installation

Install in the reverse order of removal.

NOTE:

Refer to "COMPONENT" for each tightening torque. Refer to COMPONENT , General Description.
When installing the plate guide COMPL, set the select lever to "D" range (normal mode position), and be careful of the following.

Insert protrusion (B) of the plate guide COMPL into the hole on the shift lock solenoid unit (A).
Insert link (D) of the shift lock release into link (C) of the shift lock solenoid unit.

Fig 1: Locating Shift Lock Solenoid Unit

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Shift Lock Solenoid Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.