LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System >> Driver's Airbag Module >> Removal

Driver's Airbag Module: Removal

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag module. Ref. to CAUTION , General Description.
  1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  4. Using TORX® bit T30 (1), remove the two TORX® bolts on the side of steering wheel.
    Fig 1: Removing Torx® Bolts On Side Of Steering Wheel
    G04991872Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the horn harness.
  6. Disconnect the airbag connector on the back of airbag module, and then remove the airbag module. Ref. to PROCEDURE , Airbag Connector.
    Fig 2: Identifying Airbag Connector On Back Of Airbag Module
    G05003918Courtesy of SUBARU OF AMERICA, INC.
  7. Refer to "CAUTION" for handling of a removed airbag module. Ref. to CAUTION , General Description.
scientia non olet · About LEMON Manuals