LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Inspection Mode >> Procedure >> SUBARU Select Monitor

SUBARU Select Monitor

  1. After clearing the memory, check for any remaining unresolved trouble data. Ref. to CLEAR MEMORY MODE .
  2. Warm up the engine.
  3. Prepare the Subaru Select Monitor kit. Ref. to PREPARATION TOOL , General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  4. Prepare PC with Subaru Select Monitor installed.
  5. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  6. Connect the diagnosis cable to SDI.
  7. Connect the delivery (test) mode connector (A) located under the glove box.
    Fig 2: Identifying Test Mode Connector Location
    G05346100Courtesy of SUBARU OF AMERICA, INC.
  8. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 3: Connecting SDI To Data Link Connector
    G05031666Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  9. Start up the PC.
  10. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  11. On the «Main Menu», select {Each System Check}.
  12. On the «System Selection Menu», select {Engine Control System}.
  13. Click the [OK] button after the information regarding engine type has been displayed.
  14. On the «Engine Diagnosis» display screen, select the {Dealer Check Mode Procedure}.
  15. When the «Perform Inspection (Dealer Check) Mode» is shown on the screen, click the [Next] button.
  16. Perform subsequent procedures as instructed on the display screen.
    • If trouble still remains in the memory, the corresponding DTC appears on the display screen.
      NOTE:
      • For detailed operation procedure, refer to SUBARU SELECT MONITOR .
      • For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".

        .

      • Release the parking brake.
      • The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis function.
scientia non olet · About LEMON Manuals