Check Horn

DIAGNOSIS PROCEDURE

Step	Check	Yes	No
1 CHECK HORN OPERATION. Check the horn sounds when the horn switch is pushed.	Does the horn sound?	Go to step 2.	Check the horn circuit.
2 CHECK OUTPUT TO HORN RELAY. Prepare the Subaru Select Monitor kit. Turn the ignition switch to ON (engine OFF), and run the "Application for Subaru Select Monitor III". On the System Selection Menu, select the {Integ. unit mode}. Select {Function check}. Select {Horn Output} and execute.	Does the horn sound?	Horn circuit is OK.	Go to step 3 .
3 CHECK HORN RELAY CIRCUIT. Turn the ignition switch to OFF. Disconnect the harness connector of body integrated unit (B280). Disconnect the main fuse box harness connector (B186). Measure the resistance between harness connector terminals. Connector & terminal (B280) No. 11 - (B186) No. 1:	Is the resistance less than 10 Ω?	Check the body integrated unit. Ref. to BASIC DIAGNOSTIC PROCEDURE .	Repair the harness.