LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Subaru Select Monitor >> Operation >> How To Use The SUBARU Select Monitor

How To Use The SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. Ref. to PREPARATION TOOL , General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Connecting SDI To Data Link Connector
    G05031666Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect any scan tools other than Subaru Select Monitor or general scan tool.
  6. Start up the PC.
  7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  8. Call up DTC and data, then record them.
    NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR .
scientia non olet · About LEMON Manuals