Read Diagnostic Trouble Code (DTC)
NOTE:
- DTC is displayed in the sequence of inputting. (When entering two DTCs or more simultaneously, they are displayed in the sequence of priority.)
- When more than two DTCs are displayed, perform the diagnosis of top one.
- Prepare the Subaru Select Monitor kit.
- Connect the diagnosis cable to the Subaru Select Monitor.
- Connect the Subaru Select Monitor to data link connector.
The data link connector is located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect the scan tools except for Subaru Select Monitor. - Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
- On the «Main Menu» display screen, select {Each System Check}.
- On the «System Selection Menu» display screen, select the {Integ. unit mode}.
- On the «Integ. unit mode failure diag.» display screen, select the {Diagnostic Code(s) Display}.NOTE: It is possible to read the DTC at the {All System Diagnosis} on the «Main Menu», and then find the contents to check from the DTC table. Ref. to DTC TABLE , LIST, List of Diagnostic Trouble Code (DTC).NOTE:
- For details concerning the operation procedure, refer to SUBARU SELECT MONITOR .
- For details concerning DTCs, refer to the List of Diagnostic Trouble Code (DTC). Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .