Display Of Analog Data
ANALOG DATA REFERENCE CHART
| Contents to be displayed | Unit of measure | Description | Note |
|---|---|---|---|
| BATT voltage (control) | 10 -15V | Body integrated unit input value | Always |
| BATT voltage (BACKUP) | 10-15V | Body integrated unit input value | Always |
| ABS_CM Power Voltage | 10-15V | Body integrated unit input value | Ignition switch ON |
| ACC voltage | 10-15V | Body integrated unit input value | Ignition switch ACC |
| Illumination VR Voltage | 0 -5V | Body integrated unit output value | Small light switch ON |
| Illumi. output d-ratio | 0-100% | Body integrated unit input value | Small light ON Illumination volume is other than bright. |
| ambient temp sensor V | 0 -5V | Body integrated unit input value | Ignition switch ON |
| Ambient Temperature | -40 - 87.5°C | Body integrated unit output value | Ignition switch ON |
| Fuel level voltage | 0 -8V | Body integrated unit input value | Ignition switch ON |
| Fuel level resistance | 0 - 102.3Ω | Body integrated unit input value | Ignition switch ON |
| key-lock solenoid V | 6-12V | Body integrated unit output value | Key warning switch ON, other than parking range Ignition ON |
| number of regist. | 0 - 4 | Number of keyless key registered | |
| Front Wheel Speed | km/h | CAN data input value | Reception from VDC unit |
| VDC/ABS latest f-code | DTC display (Temporarily) | CAN data input value | It is normal when DTC is not been input even if this code is displayed. Reception from VDC |
| Blower Fan Steps | 0 - 2 levels | CAN data input value | 0: OFF, 1: Low, 2: 2 levels or more Reception from air conditioner ECM |
| Fuel level resistance 2 | 0-102.3 Ω | CAN data output value | Reception from body integrated unit |
| Fuel consumption | cc/s | CAN data input value | Reception from ECM and transmission to center monitor |
| Coolant Temp. | -40 -130°C | CAN data input value | Reception from ECM |
| Vehicle lateral G | m/s2 | CAN data input value | Reception from VDC unit |
| SPORT Shift Stages | 0 - 7 levels | CAN data input value | Manual mode operating information (0: Light OFF; 1 - 5: Gear display; 6: Fail; 7: ATF temperature High/Low) Reception from TCM |
| Shift Position | 0 - 7 levels | CAN data input value | 0:1; 1:2; 2: 3; 3:4; 4: D; 5: N; 6: R; 7: P shift position (There is no 8 input.) 8 is displayed in manual mode. Reception from TCM |
| Off delay time | OFF, Short, Normal, Long | Body integrated unit setting items | Customize setting |
| Auto lock time | 20,30, 40, 50, 60 seconds | Body integrated unit setting items | Customize setting |