LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> LAN Communication System - LAN System (Diagnostics) >> Subaru Select Monitor >> Operation >> Confirmation Of Current Setting

Confirmation Of Current Setting

  1. On the «Main Menu» display screen, select {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Integ. unit mode}.
  3. On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save}.
  4. On the «Current Data Display & Save» display screen, select the {Data Display}.
  5. Using the scroll key, scroll the display screen up or down until the desired data is shown.
  6. Display the following item and record the settings.

    Required items for new registration (Except for system not equipped)

    REGISTRATION ITEM CHART

    Item Item to confirm Remarks
    # of reg key 1 2 3 4 Registered ID type
    Off delay time OFF Long Normal Short Setting for lighting off time
    Auto lock 60,50,40,30,20 OFF Not supported by North American specifications (Unit: seconds)
    Rr defogger op. mode normal continuous Normal: Off at 15 minutes of operation Continuous: Operations from switch ON to OFF
    Wiper deicer op. mode normal continuous Normal: Off at 15 minutes of operation Continuous: Operations from switch ON to OFF, repeats ON for 15 minutes, OFF for 2 minutes
    Security Alarm Setup ON OFF ON: Warning device operation possible OFF: Warning device does not operate
    Impact Sensor Setup ON OFF ON: Impact sensor operation possible OFF: Impact sensor does not operate Turn OFF for vehicles not equipped with an impact sensor
    Alarm delay setup ON OFF ON: Monitor after a fixed period of time from reception of the keyless lock signal OFF: Monitor after reception of the keyless lock signal
    Lockout prevention ON OFF Not supported by North American specifications
    Impact sensor support no support support: Impact sensor equipped no support: Impact sensor not equipped Always set to no support for vehicles not equipped with the impact sensor.
    Siren setting support no support Not supported by North American specifications
    Answer-back buzzer setup ON OFF ON: Answer-back buzzer operation possible OFF: Answer-back buzzer not operated
    Hazard answer-back setup ON OFF ON: Hazard answer-back buzzer operation possible OFF: Hazard answer-back buzzer not operated
    Automatic locking setup ON OFF Not supported by North American specifications
    Ans.-back Buzzer support no support support: Vehicle equipped with answer-back buzzer no support: Vehicle not equipped with answer-back buzzer
    Auto locking support no support Not supported by North American specifications (Set to no support)
    Door open warning (prevention of battery run-out) support no support support: Door interlocked room light goes off when on for 10 minutes consecutively when door is open. no support: Room light remains illuminated until door is closed.
    Dome Light Alarm Setting support no support support: Room light continuously lit while the alarm is triggered. no support: Even if the alarm is triggered, the room light illuminates and then turns off.
    Map Light Setting support no support support: The map light illuminates together with the door interlocked room light. no support: Does not illuminate together with the door interlocked room light.
    A/C ECM setting support no support Model with auto A/C (Set to 'support')
    P/W ECM setting support no support Not supported in North American specifications (Set to no support)
    Center display setting support no support support: Vehicle equipped with MFD and navigation display no support: Vehicle not equipped with MFD nor navigation display
    Wiper deicer support no support support: Vehicle equipped with wiper deicer no support: Vehicle not equipped with wiper deicer
    Rear fog light setting support no support Not supported in North American specifications (Set to no support)
    Factory or Market setting Factory Market Do not change to the factory mode. Set to market when using normally.
    Security setup support no support Not supported by North American specifications