LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System - Security And Locks >> Impact Sensor >> Operation >> Impact Sensor Setting Using SUBARU Select Monitor

Impact Sensor Setting Using SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. Ref. to PREPARATION TOOL , General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect USB cable to SDI (Subaru Diagnostic Interface) and PC USB port (Subaru Select Monitor dedicated port).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
    Fig 2: Locating Data Link Connector
    G05665867Courtesy of SUBARU OF AMERICA, INC.
  6. Start the PC.
  7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor III".
  8. On the System Selection Menu, select the {Integ. Unit mode}.
  9. Select {ECM customizing}.
  10. Make a impact monitor setting.
    • When installing: ON
    • When removing: OFF
  11. Make a impact monitor ON/OFF setting.
    • When installing: ON
    • When removing: OFF
  12. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
scientia non olet · About LEMON Manuals