Main Shaft Assembly For Single-Range: Installation

Install the needle bearing and oil seal to the front of the transmission single-range main shaft assembly.
NOTE:
- Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
- Apply KOPR-KOTE (or equivalent) to the sealing lip of the oil seal.
- Use a new oil seal.
Install the transmission case knock pin into the knock pin hole of the needle bearing outer race.
NOTE: Align the end face of the seal with surface (A) when installing the oil seal.

Fig 1: Identifying Seal Location
Courtesy of SUBARU OF AMERICA, INC.
Install the drive pinion shaft assembly. Ref. to INSTALLATION , Drive Pinion Shaft Assembly.
Install the transmission case. Ref. to INSTALLATION , Transmission Case.
Install the transfer case together with the extension case assembly. Ref. to INSTALLATION , Transfer Case and Extension Case Assembly.
Install the manual transmission assembly to the vehicle. Ref. to INSTALLATION , Manual Transmission Assembly.