LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback XT Limited, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Automatic Transmission 4AT (Diagnostics)) >> Subaru Select Monitor >> Operation >> Clear Memory Mode

Clear Memory Mode

WARNING: This page is about a different variant/trim than selected.
  1. Shift the select lever to "P" range.
  2. On the «Main Menu» display, select the {Each System Check}.
  3. On the «System Selection Menu» display, select the {Transmission Control System}.
  4. After transmission type information pops up, select [OK].
  5. On the «Transmission Diagnosis» display, select the {Clearing Memory}.
  6. When "Done. Turn ignition switch OFF" pops up, select [OK].
  7. Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
    NOTE:
    • If {Clear Memories 2} is selected and performed, DTC and learned control memory are cleared. If {Clear Memories 2} is performed, perform learning control promotion. Refer to FACILITATION OF LEARNING CONTROL , OPERATION, Subaru Select Monitor.
    • For detailed operation procedure, refer to the "Subaru Select Monitor ".
scientia non olet · About LEMON Manuals