Clutch Switch: Inspection
WARNING: This page is about a different variant/trim than selected.
- Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the starter interlock circuit.
- Make sure that the engine starts with the clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit.
- Check the clutch switch for continuity. If the resistance is not at the standard value, replace the switch.
- Disconnect the clutch switch connector.
- Measure the resistance between terminal 1 and 2 of the switch.TERMINALS RESISTANCE REFERENCE CHART
Condition Terminal No. Specified resistance When the clutch pedal is depressed 1 and 2 Less than 1 Ω Except when the clutch the pedal is depressed 1 and 2 1 MΩ or more Clutch switch (Clutch start)
Courtesy of SUBARU OF AMERICA, INC.
Clutch switch (Cruise control)