LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback Limited >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Drive Cycle >> Procedure >> Preparation For Drive Cycle

Preparation For Drive Cycle

  1. Check battery voltage is more than 12 V and fuel remains half [20 - 40 l  (5.3 - 10.6 US gal, 4.4 - 8.8 lmp gal)].
  2. After performing the diagnostics and clearing the memory, check that no DTC remains. Refer to CLEAR MEMORY MODE .
  3. Disconnect the delivery (test) mode connector.
    NOTE:
    • Except for the water temperature specified at starting, be sure to carry out the diagnosis after the engine is warmed up.
    • Perform the diagnosis twice if the DTC marked with *. After completing the first diagnosis, stop the engine and perform second diagnosis in same condition.
scientia non olet · About LEMON Manuals