LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback Limited >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Drive Cycle >> Procedure >> Drive Cycle H

Drive Cycle H

  1. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  2. With the ignition switch ON, read the engine coolant temperature, intake air temperature and fuel temperature. Refer to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , OPERATION, Subaru Select Monitor.
  3. If the values from step  2) satisfy the following two conditions, start the engine.

    Condition: 

    | Engine coolant temperature - intake air temperature | ≤ 5°C (41°F) 

    |Engine coolant temperature - fuel temperature | ≤2°C (36°F) 

    NOTE:
    • If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
    • Start AT vehicles in the "P" range, and MT vehicles in the neutral position.
  4. Idle the engine for 1 minute under the conditions in step  3).
    ITEM CONDITION CHART

    DTC Item Condition
    *P1602 Control Module Programming Error -
scientia non olet · About LEMON Manuals